Users Guide
Table Of Contents
- Image Assist Dynamic for Multiple Platforms Version 10.0 User's Guide
- Contents
- Introduction
- Getting started with Image Assist
- Using Image Assist Dynamic
- Image Assist Dynamic tools
- Using Image Assist Dynamic on virtual machine
- Related documents
- Frequently asked questions
- Glossary
Restore and test image
About this task
Restoring a Dynamic image and drivers enables you to test your WIM file before you submit it to Dell factory.
NOTE: If you are restoring a Reference image, there is no option to select drivers.
Steps
1. Boot to the Image Assist Dynamic USB drive or ISO file.
2. On the Welcome to Image Assist Dynamic WinPE page, in the Restore Image card, click RESTORE.
The Restore Image page is displayed.
3. Click BROWSE, select the WIM file that you want to restore, and then click OK.
4. Click BROWSE, go to the location where the driver is saved, and then click OK.
NOTE: If a valid driver pack is not detected, an error message is displayed.
5. To edit the partitions, click EDIT PARTITIONS.
6. Click RESTORE IMAGE.
After the image is restored, a confirmation window is displayed.
7. In the Restore process complete window, perform one of the following steps:
● Click SHUT DOWN to turn off the system.
● Click REBOOT to immediately restart the restored system.
8
Using Image Assist Dynamic