Reference Guide

Synopsis
• racadm inlettemphistory export –f <filename> –t <type> [–u <username of the
network share>] [–p <password for the remote share>] [-i <network share
location>]
• racadm inlettemphistory get
This command does not support proxy parameters. To perform the operation with http and https, the proxy
parameters has to be configured in the lifecyclecontroller.lcattributes. Once these proxy parameters are configured,
they become the part of default configuration. They have to be removed to ignore the proxy parameters.
The valid proxy parameters :
• UserProxyUserName
• UserProxyPassword
• UserProxyServer
• UserProxyPort
• UserProxyType
Input
• -f — Exports inlet temperature history filename. The maximum length of this parameter is 64 characters.
NOTE: If a file with the specified filename exists, then the older file is replaced with the new
history file.
• -u — User name of the remote share to export the file. Specify user name in a domain as domain or username.
• -p — Password for the remote share to where the file must be exported.
• -l — Network share location to where the inlet temperature history must be exported. The maximum length of
this parameter is 256 characters.
NOTE: The supported network locations are CIFS, NFS, HTTP, and HTTPS. Export to an IPv6
NFS share is not supported.
• -t — Specifies the exported file type. Valid values are xml and csv. These values are case-insensitive.
NOTE: From firmware RACADM, only export to a remote share is supported. The behavior of remote
share is not defined when the path specified (-l) contains special characters.
RACADM Subcommand Details 83