Release Notes

• When setting the iDRAC Service Module (ISM) monitoring attributes from the GUI, if the BIOS watchdog timer is enabled, an error
may be displayed but the attributes are set. To avoid the error, disable the BIOS watchdog timer or disable the ISM Auto System
Recovery and then apply the attributes.
• Any changes to the network settings in iDRAC take effect after 30 seconds. Any automation or user verification needs to wait for 30
seconds before verifying the new settings. iDRAC returns the old active value till the new values take effect. Any DHCP settings may
take more time (>30 seconds) depending on the network environment.
• If the system ID/Health LED turns from blue to off while running host stress test, press the ID button for one second and then press it
again to turn on the LED.
• While using a Top or Skip command, if you enter a value greater than the unsigned long type (4,294,967,295), you may get an
unrelated error message.
• Due to a limitation of Google Chrome browser, HTML5 vConsole intermittently displays the following error message: Chrome ran out
of memory while trying to display the webpage.
• When trying to save network details using the Network Configuration page of LC GUI, the following error message may be displayed:
Unable to save the IPvX network settings, where X is the version of IP (IPv4 or IPv6). The following could be one
reason for this error:
On the Network Settings page of Lifecycle Controller GUI, the IP Address Source for both IPv4 and IPv6 is either DHCP or Static
and DHCP is selected by default. So, even if you want to use only one version of IP address, LC tries to validate both versions, and
displays an error if the network details for the unintended version cannot be validated. If the error does not apply to the IP version you
are using, click
OK to close the error message. All the other settings that you configured are saved. You can either click Cancel or
Back to navigate away from the Network Settings page.
14 Limitations