Users Guide

Manufacturer Type
Broadcom
• 57414 rNDC 25GE
• 57416/5720 rNDC 10GbE
• 57412/5720 rNDC 10GbE
• 57414 PCIe FH/LP 25GE
• 57412 PCIe FH/LP 10GbE
• 57416 PCIe FH/LP 10GbE
Intel
• X710 bNDC 10Gb
• X710 DP PCIe 10Gb
• X710 QP PCIe 10Gb
• X710 + I350 rNDC 10Gb+1Gb
• X710 rNDC 10Gb
• X710 bNDC 10Gb
• XL710 PCIe 40Gb
• XL710 OCP Mezz 10Gb
• X710 PCIe 10Gb
Mellanox
• MT27710 rNDC 40Gb
• MT27710 PCIe 40Gb
• MT27700 PCIe 100Gb
QLogic
• QL41162 PCIe 10GE 2P
• QL41112 PCIe 10GE 2P
• QL41262 PCIe 25GE 2P
Inventorying and monitoring FC HBA devices
You can remotely monitor the health and view the inventory of the Fibre Channel Host Bus Adapters (FC HBA) devices in the managed
system. The Emulex and QLogic FC HBAs are supported. For each FC HBA device, you can view the following information for the ports:
• Link Status and Information
• Port Properties
• Receive and Transmit Statistics
NOTE:
Emulex FC8 HBAs are not supported.
Monitoring FC HBA devices using web interface
To view the FC HBA device information using Web interface, go to System > Overview > Network Devices > Fibre Channel. For
more information about the displayed properties, see iDRAC Online Help.
The page name also displays the slot number where the FC HBA device is available and the type of FC HBA device.
Monitoring FC HBA devices using RACADM
To view the FC HBA device information using RACADM, use the hwinventory command.
For more information, see the iDRAC RACADM CLI Guide available at www.dell.com/idracmanuals.
Dynamic configuration of virtual addresses,
initiator, and storage target settings
You can dynamically view and configure the virtual address, initiator and storage target settings, and apply a persistence policy. It allows
the application to apply the settings based on power state changes (that is, operating system restart, warm reset, cold reset, or AC cycle)
Inventorying, monitoring, and configuring network devices
175