CLI Guide

clrsel
Table 12. Details of clrsel attribute
Description
Removes all the existing records from the System Event Log (SEL).
To use this subcommand, you must have Clear Logs permission.
Synopsis
racadm clrsel [-m <module>]
Input -m <module> must be one of the following values:
● server-<n> — where n=1 to 16
● server-<nx> — where n=1 to 8; x = a, b, c, d (lower case)
Example
● racadm clrsel
The SEL was cleared successfully
● racadm clrsel -m server-1
Clear SEL log on server 1
config
Table 13. Details of config attribute
Description
Allows you to set iDRAC configuration parameters individually or to batch them as part of a configuration
file and then modify iDRAC configuration properties. If the data is different, the iDRAC object is written
with a new value.
NOTE: This subcommand will be deprecated in the later versions. For information about configurations,
see the set subcommand.
Synopsis
● racadm config -g <group> -o <object> <value>
●
racadm config -g <group> -o <object> -i <index> <value>
● racadm config -f <filename> -o [-c] [-p] [-continue]
NOTE:
● The configuration file retrieved using remote RACADM is not interoperable. For the config racadm
-r 192.168.0 -u root -p xxx config -f c:\config.txt command, use the
configuration file retrieved from the same interface. For example, for the config racadm -r
192.168.0 -u root -p xxx config -f c:\config.txt , use the file generated
from getconfig command racadm -r 192.168.0 -u root -p xxx getconfig -f c:
\config.txt.
● -f is only applicable for remote RACADM.
racadm config -g <group> -o <object> <value> [-m <module>]
Input
● -f — The -f <filename> option causes config to read the contents of the file specified by
<filename> and configure iDRAC. The file must contain data in the format specified in the section
Parsing Rules in the iDRAC User’s Guide available at www.dell.com/idracmanuals.
NOTE: The -f option is not supported for the Serial or Telnet or SSH console.
NOTE: When the –f option is specified and configuration of an attribute fails, then configuration of
other attributes in that group is skipped.
50 RACADM Subcommand Details