CLI Guide

Table Of Contents
Required License -- RACADM
Dependency -- None
BootRetryCnt -- Specify the number of retries to attempt in case of boot
failure.
Usage -- NoRetry - 0;1Retry - 1; 2Retries - 2;3Retries -
3;4Retries - 4; 5Retries - 5;6Retries- 6; IndefiniteRetries, Default - NoRetry
Required License -- RACADM
Dependency -- None
BootStrapType -- Specify the boot strap method used to boot to the
operating system.
Usage -- AutoDetect - 0;BBS - 1; Int18h - 2; Int19h- 3; Default -
AutoDetect
Required License -- RACADM
Dependency -- None
HideSetupPrompt -- Specifies whether to display or hide the legacy Option
ROM setup prompt during system Power On Self Test (POST).
Usage -- Enabled; Disabled; Default - Disabled
Required License -- RACADM
Dependency -- None
LegacyBootProto -- Select a non-UEFI network boot protocol
Usage -- PXE; iSCSI; FCoE; NONE; iSCSIPrimary; iSCSISecondary
Required License -- RACADM
Dependency -- None
LnkSpeed -- Specifies the port speed used for the selected boot
protocol
Usage -- AutoNeg; 10Mbps Half; 10Mbps Full; 100Mbps Half; 100Mbps
Full
Required License -- RACADM
Dependency -- None
NumberVFAdvertised -- The number of PCI Virtual Functions (VFs) to be
advertised on this port in non-NPAR mode.
Usage -- Values from 0 - 256, Default - 0
Required License -- RACADM
Dependency -- VLanMode has to be Enabled
VLanId -- Specifies the ID (tag) for the VLAN Mode. VLAN ID must
be in the range from 0 to 4095
Usage -- Values from 1 - 4095
Required License -- RACADM
Dependency -- VLanMode has to be Enabled
VLanMode -- Virtual LAN mode enables use of a VLAN tag to be used by
[vendor defined boot protocols]
Usage -- Enabled; Disabled
Required License -- RACADM
Dependency -- None
WakeOnLan -- Enables the server to be powered on using an in-band
magic packet
Usage -- Enabled; Disabled
Required License -- RACADM
Dependency -- None
WakeOnLanLnkSpeed -- Select the port speed used for Wake on LAN mode
Usage -- AutoNeg; 10Mbps Half; 10Mbps Full; 100Mbps Half; 100Mbps
Full
Required License -- RACADM
Dependency -- None
To view the help details of attribute level, enter the following command: racadm help <attribute name>
236
Database Objects With Get and Set Commands