CLI Guide

Table 109. Details of vflashpartition (continued)
○ The user name or password provided is not correct.
○ The file provided does not exist.
○ The memory available on the SD card is lesser than size of the image file.
● -l — Specifies the remote path relative to iDRAC.
● -u — User name for accessing the remote image.
● -p — Password for accessing the remote image.
● -a — Display the status of operations on all the existing partitions.
● list — Lists the existing partitions and its properties.
Example
● Create a 20MB empty partition.
racadm vflashpartition create -i 1 -o Drive1 -e hdd -t empty -f fat16
-s 20
● Create a partition from a remote image.
racadm vflashpartition create -i 1 -o Drive1 -e cddvd -t image -l
//ipaddress/sharefolder/isoimge.iso -u username -p xxx
A new partition is created. By default, the created partition is read-only. This command is case-sensitive
for the image filename extension. If the filename extension is in uppercase, for example FOO.ISO
instead of FOO.iso, then the command returns a syntax error.
NOTE:
○ This feature is not supported in Local RACADM.
○ Creating vFlash partition from an image file on the CFS or NFS IPv6 enabled network share is
not supported.
● Delete a partition.
racadm vflashpartition delete -i 1
● Status of operation on partition 1.
racadm vflashpartition status -i 1
● Status of all the existing partitions.
racadm vflashpartition status -a
● List all the existing partitions and its properties.
racadm vflashpartition list
vmdisconnect
Table 110. Details of vmdisconnect
Description Allows you to end another Virtual Media session. After the session ends, the web-based interface reflects
the correct connection status.
Enables an iDRAC user to disconnect all active Virtual Media sessions. The active Virtual Media sessions
are displayed on iDRAC web-based interface or by running the RACADM subcommands remoteimage or
getssninfo.
To run this subcommand, you must have the Access Virtual Media permission.
Synopsis
racadm vmdisconnect
RACADM Subcommand Details 157