CLI Guide

Table 92. Details of storage (continued)
-type option is not present, the global hotspare (ghs)
is created by default.
● To reset, clear, and import the storage configuration to the
controller, run the following command:
racadm storage
importconfig:<Controller FQDD>
racadm storage resetconfig:<Controller
FQDD>
racadm storage clearconfig:<Controller
FQDD>
● To start or stop a blink or identify operation on the
specified or PCIeSSD device, run the following command:
racadm storage blink:<FQDD>
racadm storage blink:<PCIeSSD FQDD>
racadm storage unblink:<FQDD>
racadm storage unblink:<PCIeSSD FQDD>
NOTE:
The Start or Stop a Blink feature is not
supported for HHHL PCIe SSD devices.
● To prepare the PCIeSSD drive for removal, run the
following command:
racadm storage preparetoremove
<PCIeSSD FQDD>
NOTE:
The preparetoremove task is not supported
for HHHL PCIe SSD devices.
NOTE: Ensure that the ISM is installed and running to
perform the preparetoremove operation.
● To perform a secure erase operation on PCIeSSD device,
run the following command:
racadm storage secureerase:<PCIeSSD
FQDD>
NOTE:
securerase is now supported on SED drives
along with PCIe SSD devices.
Input
● -o—Specifies the optimized version.
● -p—Specifies the property name.
● --refkey—Specifies the controller or enclosure FQDDs.
● -rl—Sets the storage level.
○ r0—storage 0-Striping
○ r1—storage 1-Mirroring
○ r5—storage 5-Striping with Parity
○ r6—storage 6-Striping with Extra Parity
○ r10—storage 10-Spanned Striping with Mirroring
○ r50—storage 50-Spanned Striping with Parity
○ r60—storage 60-Spanned Striping with Extra Parity
128 RACADM Subcommand Details