Users Guide

Message Cause Resolution
Lifecycle Controller Update
Required
• The embedded device that has
a backup of the product may
contain corrupted data.
Enable Lifecycle Controller. For
more information, see Enabling
Lifecycle Controller.
• Ungracefully exits Lifecycle
Controller for 3 consecutive
times.
Enable Lifecycle Controller. For
more information, see Enabling
Lifecycle Controller.
Lifecycle Controller not
available
Another process is using iDRAC. Wait for 30 minutes for the current
process to complete, restart the
system, and then retry.
Related Links
Disabling Lifecycle Controller
Enabling Lifecycle Controller
To enable access to Lifecycle Controller during system startup:
1. Press <F2> during POST.
The System Setup Main Menu page is displayed.
2. Select iDRAC Settings.
The iDRAC Settings page is displayed.
3. Select Lifecycle Controller.
4. Under Lifecycle Controller, select Enabled.
5. On the System Setup Main Menu page, select Finish to save the settings.
6. Select Yes to restart the system.
Disabling Lifecycle Controller
To disable access to Lifecycle Controller at system startup:
1. Press <F2> during POST.
The System Setup Main Menu page is displayed.
2. Select iDRAC Settings.
The iDRAC Settings page is displayed.
3. Select Lifecycle Controller.
4. Under Lifecycle Controller, select Disabled.
5. On the System Setup Main Menu page, select Finish to save the settings.
6. Select Yes to restart the system.
Canceling Lifecycle Controller actions
If Lifecycle Controller causes the system to restart twice, cancel the Lifecycle Controller actions.
However, if Lifecycle Controller causes the system to restart the third time, the message
Lifecycle
Controller update required is displayed, you must enable Lifecycle Controller. For more
information on enabling Lifecycle Controller, see
Enabling Lifecycle Controller.
14