Reference Guide

eth0 Link encap:Ethernet HWaddr 00:1D:

09:FF:DA:23

inet addr:10.35.155.136 Bcast:

10.35.155.255 Mask:255.255.255.0

UP BROADCAST RUNNING MULTICAST MTU:

1500 Metric:1

RX packets:2550665 errors:0 dropped:0

overruns:0 frame:0

TX packets:0 errors:0 dropped:0

overruns:0 carrier:0

collisions:0 txqueuelen:1000

RX bytes:272532097 (259.9 MiB) TX

bytes:0 (0.0 B)

inlettemphistory

Descripti

Displays the average and the peak temperatures during the last

hour, day, week, month, or year. Also Exports the inlet

temperature history data file. The file can be exported to a

remote file share, local file system, or the management station.

NOTE: For FM120x4 systems, this subcommand provides

the historical data for system board temperature.

Synopsis

• racadm inlettemphistory export –f <filename> –

t <type> [–u <username of the network

share>] [–p <password for the remote share>]

[-i <network share location>]

• racadm inlettemphistory get

Input

• -f — Exports inlet temperature history filename. The

maximum length of this parameter is 64 characters.

NOTE: If a file with the specified filename exists, then

the older file is replaced with the new history file.

• -u — User name of the remote share to export the file.

Specify user name in a domain as domain or username.

• -p — Password for the remote share to where the file must

be exported.

• -l — Network share location to where the inlet temperature

history must be exported. The maximum length of this

parameter is 256 characters.

NOTE: Export to an IPv6 NFS share is not supported.

• -t — Specifies the exported file type. Valid values are xml

and csv. These values are case-insensitive.