Reference Guide

autoupdatescheduler

Descriptio

You can automatically update the firmware of the devices on

the server.

To run this subcommand, you must have the Server Control

privilege.

NOTE:

• The autoupdatescheduler subcommand can be

enabled or disabled.

• Lifecycle Controller and CSIOR may not be enabled to

run this subcommand.

• The autoupdatescheduler can be enabled or disabled.

For more information, see

LifecycleController.LCAttributes.autoupdate (Read or

Write)

• The minimum Lifecycle Controller version required is

Lifecycle Controller 1.3.

• When a job is already scheduled and the clear

command is run, the scheduling parameters are

cleared.

• If the network share is not accessible or the catalog file

is missing when the job is scheduled, then the job is

unsuccessful.

Synopsis

• To create the AutoUpdateScheduler, run the command.

racadm autoupdatescheduler create -u <user> -

p <password> -l <location> -f <filename> -

time <time> -dom <DayOfMonth> -wom

<WeekOfMonth> -dow <DayofWeek> -rp <repeat> -

a <applyreboot> -ph <proxyHost> -pu

<proxyUser> -pp <proxyPassword> -po

• To view AutoUpdateScheduler parameter, run the

command.

racadm autoupdatescheduler view

• To clear and display AutoUpdateScheduler parameter, run

the command.

racadm autoupdatescheduler clear

NOTE: After the parameters are cleared, the

AutoUpdateSchedular is disabled. To schedule the

update again, enable the AutoUpdateScheduler.