Reference Guide

setled
Descripti
on
Sets the state (blinking or not blinking) of the LED on the
specified module.
To run this subcommand, you must have the Configure iDRAC
permission.
Synopsis
racadm setled -l <ledState>
Input • -l — Specifies the LED state. The values are:
– 0 — No Blinking
– 1 — Blinking
Example
• From iDRAC stop LED from blinking.
racadm setled -l 0
RAC0908: System ID LED blink off.
• From iDRAC start LED to blink.
racadm setled -l 1
RAC0907: System ID LED blink on.
setniccfg
Descripti
on
Sets the iDRAC IP address for static and DHCP modes.
To run this subcommand, you must have the Configure iDRAC
privilege.
.
NOTE: The terms NIC and Ethernet management port may
be used interchangeably.
Synopsis
• racadm setniccfg -d
• racadm setniccfg -d6
• racadm setniccfg -s <IPv4Address> <netmask>
<IPv4 gateway>
• racadm setniccfg -s6 <IPv6 Address> <IPv6
Prefix Length> <IPv6 Gateway>
• racadm setniccfg -o
101