Users Guide

Configuring Standard Schema Active Directory
To configure iDRAC for a Active Directory login access:
1. On an Active Directory server (domain controller), open the Active Directory Users and Computers Snap-in.
2. Create a group or select an existing group. Add the Active Directory user as a member of the Active Directory group to
access iDRAC.
3. Configure the group name, domain name, and the role privileges on iDRAC using the iDRAC Web interface or RACADM.
Related tasks
Configuring Active Directory With Standard Schema Using iDRAC Web Interface on page 122
Configuring Active Directory With Standard Schema Using RACADM on page 122
Configuring Active Directory With Standard Schema Using iDRAC Web
Interface
NOTE: For information about the various fields, see the iDRAC Online Help.
1. In the iDRAC Web interface, go to Overview > iDRAC Settings > User Authentication > Directory Services >
Microsoft Active Directory.
The Active Directory summary page is displayed.
2. Click Configure Active Directory.
The Active Directory Configuration and Management Step 1 of 4 page is displayed.
3. Optionally, enable certificate validation and upload the CA-signed digital certificate used during initiation of SSL connections
when communicating with the Active Directory (AD) server. For this, the Domain Controllers and Global Catalog FQDN must
be specified. This is done in the next steps. And hence the DNS should be configured properly in the network settings.
4. Click Next.
The Active Directory Configuration and Management Step 2 of 4 page is displayed.
5. Enable Active Directory and specify the location information about Active Directory servers and user accounts. Also, specify
the time iDRAC must wait for responses from Active Directory during iDRAC login.
NOTE:
If certificate validation is enabled, specify the Domain Controller Server addresses and the Global Catalog FQDN.
Make sure that DNS is configured correctly under Overview > iDRAC Settings > Network.
6. Click Next. The Active Directory Configuration and Management Step 3 of 4 page is displayed.
7. Select Standard Schema and click Next.
The Active Directory Configuration and Management Step 4a of 4 page is displayed.
8. Enter the location of Active Directory global catalog server(s) and specify privilege groups used to authorize users.
9. Click a Role Group to configure the control authorization policy for users under the standard schema mode.
The Active Directory Configuration and Management Step 4b of 4 page is displayed.
10. Specify the privileges and click Apply.
The settings are applied and the Active Directory Configuration and Management Step 4a of 4 page is displayed.
11. Click Finish. The Active Directory settings for standard schema is configured.
Configuring Active Directory With Standard Schema Using RACADM
To configure iDRAC Active Directory with Standard Schema using the RACADM:
1. At the racadm command prompt, run the following commands:
● Using config command:
racadm config -g cfgActiveDirectory -o cfgADEnable 1
racadm config -g cfgActiveDirectory -o cfgADType 2
racadm config -g cfgStandardSchema -i <index> -o cfgSSADRoleGroupName <common name
of the role group>
racadm config -g cfgStandardSchema -i <index> -o cfgSSADRoleGroupDomain <fully
122
Configuring User Accounts and Privileges