Users Guide

Using SOL From OpenSSH or Telnet On Linux on page 106
Using SOL From Putty On Windows
To start IPMI SOL from PuTTY on a Windows management station:
NOTE: If required, you can change the default SSH or Telnet time-out at Overview > iDRAC Settings > Network >
Services.
1. Run the command to connect to iDRAC: putty.exe [-ssh | -telnet] <login name>@<iDRAC-ip-address>
<port number>
NOTE: The port number is optional. It is required only when the port number is reassigned.
2. Run the command console com2 or connect to start SOL and boot the managed system.
A SOL session from the management station to the managed system using the SSH or Telnet protocol is opened. To access
the iDRAC command line console, follow the ESC key sequence. Putty and SOL connection behavior:
● While accessing the managed system through putty during POST, if the The Function keys and keypad option on putty is
set to:
○ VT100+ — F2 passes, but F12 cannot pass.
○ ESC[n~ — F12 passes, but F2 cannot pass.
● In Windows, if the Emergency Management System (EMS) console is opened immediately after a host reboot, the Special
Admin Console (SAC) terminal may get corrupted. Quit the SOL session, close the terminal, open another terminal, and
start the SOL session using the same command.
Related concepts
Disconnecting SOL Session in iDRAC Command Line Console on page 107
Using SOL From OpenSSH or Telnet On Linux
To start SOL from OpenSSH or Telnet on a Linux management station:
NOTE:
If required, you can change the default SSH or Telnet session time-out at Overview > iDRAC Settings > Network
> Services.
1. Start a shell.
2. Connect to iDRAC using the following command:
● For SSH: ssh <iDRAC-ip-address> -l <login name>
● For Telnet: telnet <iDRAC-ip-address>
NOTE:
If you have changed the port number for the Telnet service from the default (port 23), add the port number to
the end of the Telnet command.
3. Enter one of the following commands at the command prompt to start SOL:
● connect
● console com2
This connects iDRAC to the managed system’s SOL port. Once a SOL session is established, iDRAC command line console
is not available. Follow the escape sequence correctly to open the iDRAC command line console. The escape sequence is
also printed on the screen as soon as a SOL session is connected. When the managed system is off, it takes sometime to
establish the SOL session.
NOTE: You can use console com1 or console com2 to start SOL. Reboot the server to establish the connection.
The console -h com2 command displays the contents of the serial history buffer before waiting for input from the
keyboard or new characters from the serial port.
The default (and maximum) size of the history buffer is 8192 characters. You can set this number to a smaller value using
the command:
racadm config -g cfgSerial -o cfgSerialHistorySize <number>
4. Quit the SOL session to close an active SOL session.
106
Setting Up iDRAC Communication