Users Guide

Configuring SMTP Email Server Address Settings
You must configure the SMTP server address for email alerts to be sent to specified destinations.
Configuring SMTP Email Server Address Settings Using iDRAC Web Interface
To configure the SMTP server address:
1. In iDRAC Web interface, go to Overview > Server > Alerts > SNMP and E-mail Settings.
2. Enter the valid IP address or fully qualified domain name (FQDN) of the SMTP server to be used in the configuration.
3. Select the Enable Authentication option and then provide the user name and password (of a user who has access to SMTP server).
4. Enter the SMTP port number.
For more information about the fields, see the iDRAC Online Help.
5. Click Apply.
The SMTP settings are configured.
Configuring SMTP Email Server Address Settings Using RACADM
To configure the SMTP email server, use one of the following:
• Using set command:
racadm set iDRAC.RemoteHosts.SMTPServerIPAddress <SMTP E-mail Server IP Address>
• Using config command:
racadm config -g cfgRemoteHosts -o cfgRhostsSmtpServerIpAddr <SMTP E-mail Server IP
Address>
Configuring WS Eventing
The WS Eventing protocol is used for a client service (subscriber) to register interest (subscription) with a server (event source) for
receiving messages containing the server events (notifications or event messages). Clients interested in receiving the WS Eventing
messages can subscribe with iDRAC and receive Lifecycle Controller job related events.
The steps required to configure WS eventing feature to receive WS Eventing messages for changes related to Lifecycle Controller jobs
are described in the Web service Eventing Support for iDRAC 1.30.30 specification document. In addition to this specification, see the
DSP0226 (DMTF WS Management Specification), Section 10 Notifications (Eventing) document for the complete information on the WS
Eventing protocol. The Lifecycle Controller related jobs are described in the DCIM Job Control Profile document.
Alerts Message IDs
The following table provides the list of message IDs that are displayed for the alerts.
Table 22. Alert Message IDs
Message ID Description
AMP Amperage
ASR Auto Sys Reset
BAR Backup/Restore
BAT Battery Event
BIOS BIOS Management
BOOT BOOT Control
CBL Cable
146 Configuring iDRAC to Send Alerts