Users Guide

• During the update, chassis action power commands are disabled.
The updates for components such as Programmable System-on-Chip (PSoC) of IOM that requires all the
servers to be idle, the update is applied on the next chassis power-up cycle.
CMC Settings to Update CMC Firmware from iDRAC
In FX2/FX2s chassis, before performing the firmware update from iDRAC for CMC and its shared
components, do the following:
1. Launch the CMC Web interface
2. Navigate to Chassis Overview → Setup → General.
3. From the Chassis Management at Server Mode drop-down menu, select Manage and Monitor, and
the click Apply.
iDRAC Settings to Update CMC Firmware
In FX2/FX2s chassis, before updating the firmware for CMC and its shared components from iDRAC, do
the following settings in iDRAC:
1. In the iDRAC Web interface, go to Overview → iDRAC Settings → Update and Rollback → Settings
The Chassis Management Controller Firmware Update Settings page is displayed.
2. For Allow CMC Updates Through OS and Lifecycle Controller, select Enabled to enable CMC
firmware update from iDRAC.
3. Under Current CMC Setting, make sure that Chassis Management at Server Mode option displays
Manage and Monitor. You can set this in CMC.
Viewing and Managing Staged Updates
You can view and delete the scheduled jobs including configuration and update jobs. This is a licensed
feature. All jobs queued to run during the next reboot can be deleted.
Related Links
Updating Device Firmware
Viewing and Managing Staged Updates Using iDRAC Web interface
To view the list of scheduled jobs using iDRAC Web interface, go to Overview → Server → Job Queue.
The Job Queue page displays the status of jobs in the Lifecycle Controller job queue. For information
about the displayed fields, see the
iDRAC Online Help.
To delete job(s), select the job(s) and click Delete. The page is refreshed and the selected job is removed
from the Lifecycle Controller job queue. You can delete all the jobs queued to run during the next reboot.
You cannot delete active jobs, that is, jobs with the status Running or Downloading.
You must have Server Control privilege to delete jobs.
Viewing and Managing Staged Updates Using RACADM
To view the staged updates using RACADM, use jobqueue subcommand. For more information, see the
iDRAC8 RACADM Command Line Interface Reference Guide available at dell.com/support/manuals.
73