Connectivity Guide

iDRAC8 MIB

The Integrated Dell Remote Access Controller (iDRAC) MIB (filename iDRAC-SMIv1.mib/ iDRAC-

SMIv2.mib) is the MIB supported by the Integrated Dell Remote Access Controller 8 (iDRAC8). This MIB

provides management data that allows you to monitor devices and software on a system via an out-of-

band connection to the iDRAC8 of a system.

NOTE: From iDRAC7 firmware release r1.30.30 or later and iDRAC8, the iDRAC7 or iDRAC8 MIB file

is published in both types of SMI (Structure of Managed Information) notations: SMIv1 and SMIv2.

The SMIv1 copy of the iDRAC7 or iDRAC8 MIB file is named iDRAC-SMIv1.mib. And the SMIv2 copy

is named iDRAC-SMIv2.mib. Prior to iDRAC7 firmware release r1.30.30, only a SMIv1 copy was

published. And the file name of the SMIv1 copy was iDRAC-MIB.txt

Supported Systems

The iDRAC8 MIB is supported on the following systems:

Rack and Tower Servers

The Rack and Tower servers for this release:

• PowerEdge R730

• PowerEdge R730xd

• PowerEdge R630

• PowerEdge T630

• PR7910

• C4130

iDRAC8 Supported SNMP Versions

The following table identifies the SNMP versions that support iDRAC8 for the given SNMP operations.

SNMP Operations Supported SNMP version

GET, GETNEXT, GETBULK SNMP v1, v2c and v3

TRAP SNMP v1, SNMP v2c and SNMP v3

NOTE: iDRAC8 does not support the SNMP SET operation for any data

NOTE: iDRAC7 firmware release r1.30.30 or later and iDRAC8 supports SNMP query operations

(GET, GETNEXT, GETBULK) via the SNMPv3 protocol. In addition to supporting query operations via

the SNMP v1 and SNMP v2c protocols, SNMP User Security Model (USM) is supported.