Connectivity Guide

Description Line Item Explanation

Processor sensor status: Configuration error

Redundancy unit:

<Redundancy location

in chassis>

Specifies the location of the redundant power supply or cooling unit in

the chassis, for example:

Redundancy unit: Fan Enclosure

SD card device type:

<Type of SD card

device>

Specifies the type of SD card device, for example:

SD card device type: Hypervisor

SD card state: <State

of SD card>

Specifies the state of the SD card, for example:

SD card state: Present, Failed

Sensor location:

Specifies the location of the sensor in the specified chassis, for example:

Sensor location: CPU1

Temperature sensor

value (in degrees

Celsius): <Reading>

Specifies the temperature in degrees Celsius, for example:

Temperature sensor value (in degrees Celsius): 30

Voltage sensor value

(in Volts): <Reading>

Specifies the voltage sensor value in volts, for example:

Voltage sensor value: 1.693

Understanding Trap Severity

Traps often contain information about values recorded by probes or sensors. Probes and sensors monitor

critical components for values such as amperage, voltage, and temperature. When an event occurs on

your system, the Server Administrator sends information about one of the following event types to the

system management console:

• Information/Informational—An event that describes the successful operation of a unit, such as a

power supply turning on or a sensor reading returning to normal.

• Warning — An event that is not necessarily significant, but may indicate a possible future problem,

such as crossing a warning threshold.

• Critical/Error — A significant event that indicates actual or imminent loss of data or loss of function,

such as crossing a failure threshold or a hardware failure.

RAC Traps

This section describes the traps that are generated by the SNMP agent of the Remote Access Controller

(RAC). All of the enterprise-specific traps documented in this section belong to the MIB enterprise

identified by OID 1.3.6.1.4.1.674.10892.2 and are sent with all of the trap variables documented in the

section Traps . The trap variables are sent in the order in which they are listed.

NOTE: The PowerEdge M1000e CMC and PowerEdge VRTX CMC do not generate the traps in this

section. They generate the traps documented in the CMC Traps.