Reference Guide

To export the collected Tech Support Report to the local file system.
racadm techsupreport export -f tsr_report.zip
testemail
Description
Sends a test email from iDRAC to a specified destination. Prior to running the test email command, make sure
that the SMTP server is configured.
The specified index in the idrac.EmailAlert group must be enabled and configured properly. For more
information, see the see the Integrated Dell Remote Access Controller (iDRAC8) and iDRAC7 RACADM
Command Line Interface Reference Guide available at dell.com/support/manuals.
Synopsis
racadm testemail -i <index>
Input -i <index> — Specifies the index of the email alert to test.
Output
Success: Test e-mail sent successfully
Failure: Unable to send test e-mail
Example
Commands for the idrac.EmailAlert group:
Enable the alert.
racadm set idrac.EmailAlert.1.Enable 1
Set the destination email address.
racadm set idrac.EmailAlert.1.Address user1@mycompany.com
Set the custom message that is sent to the destination email address.
racadm set idrac.emailalert.1.CustomMsg "This is a test!"
Make sure that the SMTP IP address is configured properly.
racadm set idrac.remotehosts.SMTPServerIPAddress 192.168.0
View the current email alert settings.
racadm get idrac.EmailAlert.<index>
where <index> is a number from 1 to 8.
testtrap
Description
Tests the RAC’s SNMP trap alerting feature by sending a test trap from iDRAC to a specified destination trap
listener on the network.
To run this subcommand, you must have the Test Alert permission.
NOTE:
Before you run the testtrap subcommand, make sure that the specified index in the RACADM
iDRAC.SNMP.Alert group is configured properly.
The indices of testtrap subcommand is co-related to the indices of iDRAC.SNMP.Alert group.
Synopsis
racadm testtrap -i <index>
Input -i <index> — Specifies the index of the trap configuration that must be used for the test. Valid values are
from 1 to 4.
Example
Enable the alert.
racadm set idrac.emailalert.1.CustomMsg 1
racadm set iDRAC.SNMP.Alert.1.Enable 1
95