Reference Guide

– Make note of the Job ID output by the Set command.
– After reboot, wait for the job to complete by checking the job status.
racadm jobqueue view –i <Job ID>
• Configure a systems using a local Server Configuration Profile XML file containing a mix of real-time and
staged objects; postpone reboot until other operations have been completed.
racadm set -f myfile.xml -t xml -b NoReboot
– Make note of the Job ID output by the Set command; because of the NoReboot option, the job will be
pending until the server is rebooted
– Complete other operations, then perform a reboot
– After reboot, wait for the job to complete by checking the job status
racadm jobqueue view –i <Job ID>
• Verify the Server Configuration Profile XML file content located in a remote CIFS share.
racadm set -f temp_Configuration_file -t xml -u Administrator -p Password
-l //192.168.0/xyz –preview
setled
Description Sets the state (blinking or not blinking) of the LED on the specified module.
To run this subcommand, you must have the Configure iDRAC permission.
Synopsis
racadm setled -l <ledState>
Input
• -l <ledState> — Specifies the LED state. The values are:
– 0 — No Blinking
– 1 — Blinking
Example
• From iDRAC stop LED from blinking.
racadm setled -l 0
RAC0908: System ID LED blink off.
• From iDRAC start LED to blink.
racadm setled -l 1
RAC0907: System ID LED blink on.
setniccfg
Description
Sets the iDRAC IP address for static and DHCP modes.
To run this subcommand, you must have the Configure iDRAC privilege.
NOTE: The terms NIC and Ethernet management port may be used interchangeably.
Synopsis
• racadm setniccfg -d
• racadm setniccfg -d6
• racadm setniccfg -s <IPv4Address> <netmask> <IPv4 gateway>
• racadm setniccfg -s6 <IPv6 Address> <IPv6 Prefix Length> <IPv6 Gateway>
•
racadm setniccfg -o
Input
• -d — Enables DHCP for the NIC. It is enabled by default.
• -d6 — Enables AutoConfig for the NIC (default is disabled).
69