Reference Guide

User name to access the network share. For domain users, you can use the following formats:

– domain/user

– domain\user

– user@domain

• -p — Password to access the network share.

Example

• Configure a Remote image.

racadm remoteimage -c -u "user" -p "xxx" -l //shrloc/foo.iso

Remote Image is now Configured

• Disable Remote File Sharing.

racadm remoteimage -d

Disable Remote File Started. Please check status using -s option to know

Remote File Share is ENABLED or DISABLED.

• Check Remote File Share status.

racadm remoteimage -s

Remote File Share is Enabled

UserName

Password

ShareName //192.168.0/xxxx/dtk_3.3_73_Linux.iso

• Deploy a remote image on iDRAC CIFS Share.

racadm remoteimage -c -u admin -p xxx -l //192.168.0/dev/floppy.img

• Deploy a remote image on iDRAC NFS Share.

racadm remoteimage -c -u admin -p xxx -l '//192.168.0/dev/floppy.img'

rollback

Description

Allows you to roll back the firmware to an earlier version.

Synopsis

racadm rollback <FQDD> [--reboot]

NOTE: To get the list of available rollback versions and FQDDs, run the racadm swinventory

command.

Input

• <FQDD>: Specify the FQDD of the device for which the rollback is required.

• --reboot: Performs a graceful system reboot after the BIOS firmware rollback.

Example

• To perform BIOS firmware rollback:

racadm rollback iDRAC.Embedded.1-1

RAC1056: Rollback operation initiated successfully.

• To perform a graceful system reboot after BIOS firmware rollback:

racadm rollback BIOS.Setup.1-1 --reboot

sensorsettings

Description

Allows you to perform threshold settings of the sensor.

To run this subcommand, you must have Configure iDRAC privilege.