Users Guide

Manufacturer Type
• ConnectX-3 Pro 10G
Qlogic
• QME2662 Mezz FC16
• QLE2660 PCIe FC16
• QLE2662 PCIe FC16
Emulex
• LPM16002 Mezz FC16
• LPe16000 PCIe FC16
• LPe16002 PCIe FC16
• LPM16002 Mezz FC16
• LPM15002
• LPe15000
• LPe15002
• OCm14104B-UX-D
• OCm14102B-U4-D
• OCm14102B-U5-D
• OCe14102B-UX-D
• OCm14104B-UX-D
• OCm14102B-U4-D
• OCm14102B-U5-D
• OCe14102B-UX-D
• OCm14104-UX-D rNDC 10Gb
• OCm14102-U2-D bNDC 10Gb
• OCm14102-U3-D Mezz 10Gb
• OCe14102-UX-D PCIe 10Gb
Supported NIC rmware versions for I/O Identity Optimization
In 13th generation Dell PowerEdge servers, the required NIC rmware is available by default.
The following table provides the NIC rmware versions for the I/O identity optimization feature.
Virtual/Flex Address and Persistence Policy behavior when iDRAC is set to Flex Address mode
or Console mode
The following table describes the Virtual address management (VAM) conguration and Persistence Policy behavior depending on
Flex Address feature state in CMC, mode set in iDRAC, I/O Identity feature state in iDRAC, and XML conguration.
Table 30. Virtual/Flex Address and Persistence Policy behavior
Flex Address
Feature State in
CMC
Mode set in iDRAC IO Identity Feature
State in iDRAC
XML Conguration Persistence Policy Clear Persistence
Policy — Virtual
Address
Flex Address
enabled
FlexAddress Mode Enabled Virtual address
management
(VAM) congured
Congured VAM
persists
Set to Flex Address
Flex Address
enabled
FlexAddress Mode Enabled VAM not congured Set to Flex Address No persistence —
Is set to Flex
Address
Flex Address
enabled
Flex Address Mode Disabled Congured using
the path provided in
Lifecycle Controller
Set to Flex Address
for that cycle
No persistence —
Is set to Flex
Address
175