Users Guide

The Alert Recurrence page is displayed.
2. In the Recurrence column, enter the alert frequency value for the required category, alert, and severity type(s).
For more information, see the iDRAC Online help.
3. Click Apply.
The alert recurrence settings are saved.
Setting alert recurrence events using RACADM
To set the alert recurrence event using RACADM, use the eventlters command. For more information, see the iDRAC RACADM
Command Line Interface Reference Guide
available at dell.com/idracmanuals.
Setting event actions
You can set event actions such as perform a reboot, power cycle, power o, or perform no action on the system.
Related links
Filtering alerts
Enabling or disabling alerts
Setting event actions using web interface
To set an event action:
1. In iDRAC Web interface, go to Overview → Server → Alerts. The Alerts page is displayed.
2. Under Alerts Results, from the Actions drop-down menu, for each event select an action:
• Reboot
• Power Cycle
• Power O
• No Action
3. Click Apply.
The setting is saved.
Setting event actions using RACADM
To congure an event action, use the eventlters command. For more information, see the iDRAC RACADM Command Line
Interface Reference Guide available at dell.com/idracmanuals.
Conguring email alert, SNMP trap, or IPMI trap settings
The management station uses Simple Network Management Protocol (SNMP) and Intelligent Platform Management Interface
(IPMI) traps to receive data from iDRAC. For systems with large number of nodes, it may not be ecient for a management station
to poll each iDRAC for every condition that may occur. For example, event traps can help a management station with load balancing
between nodes or by issuing an alert if an authentication failure occurs. SNMP v1, v2, and v3 formats are supported.
You can congure the IPv4 and IPv6 alert destinations, email settings, and SMTP server settings, and test these settings. You can
also specify the SNMP v3 user to whom you want to send the SNMP traps.
Before conguring the email, SNMP, or IPMI trap settings, make sure that:
• You have Congure RAC permission.
• You have congured the event lters.
155