Reference Guide

○ g — Specifies the size in gigabytes
○ t — Specifies the size in terabytes
● -sc — Number of spans in a virtual disk (required for multi-span RAID level).
NOTE:
○ For PERC9, if the value of controller.SupportRAID10UnevenSpans is supported, you
can enter only 0 for this option while creating RAID level 10. The created RAID10 virtual disk will
display the spandepth as 1 (default).
○ For other controllers:
￭ The default value for multi-span RAID levels is 2 and for basic RAID level is 1.
￭ For hybrid RAID levels such as RAID10, RAID50, and RAID60, this option is mandatory.
￭ The value for-sc option can be 0 only for RAID10.
● -T10PIEnable — Creates a virtual disk with protection information.
● -key <Key id> — Specifies the key id.
● -passwd <passphrase> — Specifies the passphrase.
● -newpasswd <passphrase> — Specifies the new passphrase.
● -assign {yes | no} — Assigns or unassigns the disk as a hotspare.
● -type { ghs | dhs} — Assigns a global or dedicated hotspare.
● -vdkey:<VD FQDD> — Assigns the dedicated hotspare to the specified virtual disk. This option is
required for dedicated hotspare.
● -state <start|stop> — start value starts a patrol read operation. stop value stops a running
patrol read operation.
NOTE: To start the operation, the Controller.PatrolReadMode must be in Manual mode.
● -speed — Specifies the initialization of the Virtual disk.
○ fast— Performs fast initialization.
○ full— Performs slow initialization.
● blink: <FQDD> or unblink: <FQDD> — <FQDD> can be physical disk drives, virtual disks, or
PCIeSSD.
● <PCIeSSD FQDD> — Specifies the PCIeSSD FQDD.
● <PCIeSSD controller|enclosure FQDD> — Specifies the PCIeSSD controller or enclosure
FQDD.
● preparetoremove — Specifies the PCIeSSD drive to prepare for removal.
NOTE: Ensure that ISM is installed and running to perform the preparetoremove operation.
● secureerase— Specifies the PCIeSSD drive to perform the secure erase operation.
Example
Inventory
● To view the help details for get command, run the following command:
racadm>>storage help get
racadm storage help get
Storage monitoring and inventory of hardware RAID connected to the system.
Usage :
racadm storage get status
racadm storage help <Object type I/II>
racadm storage get <Object type I>
racadm storage get <Object type I> -current
racadm storage get <Object type I> -pending
racadm storage get <Object type I> -o
racadm storage get <Object type I> -o -p <property names separated by comma>
racadm storage get <Object type I>:<FQDD's of Object type I separated by comma> -p
<property names separated by comma>
racadm storage get <Object type I>:<FQDD's of Object type I separated by comma>
racadm storage get <Object type II> --refkey <reference keys separated by comma>
racadm storage get <Object type II> --refkey <reference keys separated by comma> -o
racadm storage get <Object type II> --refkey <reference keys separated by comma> -o
-p <property names separated by comma>
86
RACADM Subcommand Details