Release Notes

To distinguish between the port numbers, see the MAC address or the Device Settings.
You can access Device Settings in the following methods:
• During POST, press <F2>, and then click
System Setup
.
• On the Lifecycle Controller Home page, click System Setup, and then click Advanced Hardware
Configuration.
Versions
/
Systems
Affected
All LC–supported Dell PowerEdge servers
Issue 5:
Description
After you successfully update the firmware of a CPLD on a modular server, and then perform a firmware
update operation of a component that requires a system restart (such as BIOS), the server is automatically
and repeatedly restarted.
Resolution
Perform a Power Cycle operation on the server.
Versions
/
Systems
Affected
All LC–supported Dell PowerEdge servers.
Issue 6:
Description
Lifecycle Controller may go into an infinite loop when a network operation is tried with an incorrect NFS
share name.
Resolution
Restart Lifecycle Controller and retry the operation with the correct NFS share name details.
Versions
/
Systems
Affected
All LC–supported Dell PowerEdge servers.
Issue 7:
Description
On the Dell 12th generation of PowerEdge servers, while deploying the operating system by selecting the
UEFI boot mode, an error message is displayed when you click
Finish
. This error occurs if you try to
connect the optical drive or virtual media after you launch Lifecycle Controller.
Resolution
Reboot the server and ensure that you connect the optical drive or virtual media before launching
Lifecycle Controller.
Versions
/
Systems
Affected
All LC–supported Dell PowerEdge servers.
Issue 8:
Description
If NPAR is enabled, Lifecycle Controller might show unexpected behavior when configuring network
settings.
Resolution
Disable the
NPAR
option and execute the network setting configurations. To disable the
NPAR
option, go
to
System Setup
->
Device Setting
.