Release Notes

Issue 22:
Description
After updating the firmware on an enclosure connected to a 12Gbps SAS Controller, the updated
firmware version is not displayed in the inventory or through any of the interfaces (iDRAC GUI, RACADM)
until the server is powered off and then powered back on.
Resolution
Power the server off then power it on. The updated firmware version is displayed.
Versions
/
Systems
Affected
All Dell PowerEdge systems with iDRAC8.
Issue 23:
Description
Updating multiple iDRAC DUP using the web interface is not successful when the total size of the DUPs
exceeds 300 MB.
Resolution
Make sure the total size is less than 300 MB and then perform an update.
Versions
/
Systems
Affected
All Dell PowerEdge systems with iDRAC8.
Issue 24:
Description
Repository update operations through iDRAC with reserved characters in user name and password may
not be successful at the DUP download stage, even when they are properly percent encoded by the user.
This does not affect other update methods.
Resolution
Use a user name and password without reserved characters and then perform an update.
Versions
/
Systems
Affected
All Dell PowerEdge systems with iDRAC8.
Issue 25:
Description
On the Dell 13
th
generation PowerEdge servers, after replacing the motherboard, if you use the Easy
Restore feature to restore the UEFI Diagnostic utility, the UEFI Diagnostic is restored successfully.
However, the iDRAC web interface may not show the restored Diagnostic version in the System Inventory
page.
Resolution
Reset iDRAC.
Versions
/
Systems
Affected
All Dell PowerEdge systems with iDRAC8.
Issue 26:
Description
On the Dell 13
th
generation PowerEdge servers, a clone export of a system with 64 virtual disks does not
recreate the virtual disks on the target system.
Resolution