Release Notes

Issue 56:
Description
After upgrading iDRAC from version 1.57.57 to 2.20.20.20, the job status in the job queue page in the iDRAC GUI is
marked as Completed (0%).
Resolution
The 0% does not indicate anything and the job is complete.
Versions/ Systems Affected
All Dell PowerEdge systems with iDRAC 1.57.57.
Issue 57:
Description
EOL/Obsolete Software SNMP version detected. [Qualysguard]
Resolution
By default, iDRAC enables SNMP v1, v2, and v3 protocol to validate SNMP queries and gets received from remote
systems requesting SNMP data access. Disable SNMP service if not using. To secure credentials, enable SNMP v3
only using RACADM or iDRAC Web interface.
Versions/Systems Affected
All Dell PowerEdge systems with iDRAC8.
Issue 58:
Description
SNMP Agent Default Community Name (public). [Nessus]
Resolution
iDRAC provides limited read-only information to third-party tools for identification purposes only. The SNMP Agent
is enabled by default and uses the default SNMP community name. The SNMP Agent can be disabled or SNMP
community name can be changed if not using 3rd party tools.
Versions/Systems Affected
All Dell PowerEdge systems with iDRAC8.
Issue 59:
Description
SSL Certificate - Self-Signed Certificate. [Qualysguard, Nesssus, Rapid7, Retina].
Resolution
iDRAC default SSL Certificate is self-signed by iDRAC. Upload a 3rd party or in-house CA signed SSL certificate.
Versions/Systems Affected
All Dell PowerEdge systems with iDRAC8.
Issue 60:
Description
While setting the value for uefidevicepath by using RACADM interface, the value displayed in the iDRAC GUI
and virtual console is BIOS Setup instead of FirstBootDevice. However, the correct value is displayed on
interfaces such as Redfish, RACADM, and WS-MAN.
Resolution
None
Versions/Systems Affected
All Dell PowerEdge systems with iDRAC8.