Concept Guide

New In This Release
• Added iDRAC.NIC.VLanPort attribute to enable the VLAN switch.
• Added iDRACHardReset to reset iDRAC when unresponsive.
• Added iDRAC.Redfish.Enable attribute to enable or disable Redfish service.
• Added iDRAC.Redfisheventing.DeliveryRetryAttempts attribute to specify the number of retry attempts made for
Redfish event delivery.
• Added iDRAC.Redfisheventing.DeliveryRetryIntervalInSeconds attribute to specify the retry interval of Redfish event
delivery interval in seconds.
• Added iDRAC.Redfisheventing.IgnoreCertificateErrors attribute to enable or disable ignorance of certificate errors
notification.
•
Added BIOS.IntegratedDevices.GlobalSlotDriverDisable attribute to control the pre-boot driver on any slot.
• Added BIOS.Procsettings.Proc2Cores, BIOS.Procsettings.Proc3Cores, and BIOS.Procsettings.Proc4Cores attributes to
control the number of enabled cores in each processor.
• Added BIOS.SysProfileSettings.WriteDataCrc attribute to detect the DDR4 data bus issues and to resolve it during the
write operation.
• Added BIOS.SysSecurity.TpmFirmware attribute to display the firmware version of the Trusted Platform Module (TPM).
• Added BIOS.SysSecurity.TpmPpiBypassClear attribute to clear the Physical Presence Interface (PPI) and, the Advanced
Configuration and Power Interface (ACPI). It also enables the operating system to bypass the PPI-related prompts.
• Added BIOS.SysSecurity.TpmPpiBypassProvision attribute to enable or disable the Physical Presence Interface (PPI), and
the Advanced Configuration and Power Interface (ACPI). It also enables the operating system to by-pass the PPI-related
prompts.
• Added support for enhanced and flexible backplane zoning or split modes.