Reference Guide

NOTE:
– For PERC9, if the value of controller.SupportRAID10UnevenSpans is
supported, you can enter only 0 for this option while creating RAID level
10. The created RAID10 virtual disk will display the spandepth as
1 (default).
– For other controllers:
* The default value for multi-span RAID levels is 2 and for basic RAID level
is 1.
* For hybrid RAID levels such as RAID10, RAID50, and RAID60, this option
is mandatory.
* The value for-sc option can be 0 only for RAID10.
• -T10PIEnable — Creates a virtual disk with protection information.
• -key <Key id> — Specifies the key id.
• -passwd <passphrase> — Specifies the passphrase.
• -newpasswd <passphrase> — Specifies the new passphrase.
• -assign {yes | no} — Assigns or unassigns the disk as a hotspare.
• -type { ghs | dhs} — Assigns a global or dedicated hotspare.
• -vdkey:<VD FQDD> — Assigns the dedicated hotspare to the specified virtual disk.
This option is required for dedicated hotspare.
• -state <start|stop> — start value starts a patrol read operation. stop value
stops a running patrol read operation.
NOTE: To start the operation, the Controller.PatrolReadMode must be in
Manual mode.
• -speed — Specifies the initialization of the Virtual disk.
– fast— Performs fast initialization.
– full— Performs slow initialization.
• blink: <FQDD> or unblink: <FQDD> — <FQDD> can be physical disk drives,
virtual disks, or PCIeSSD.
• <PCIeSSD FQDD> — Specifies the PCIeSSD FQDD.
• <PCIeSSD controller|enclosure FQDD> — Specifies the PCIeSSD controller or
enclosure FQDD.
• preparetoremove — Specifies the PCIeSSD drive to prepare for removal.
NOTE: Ensure that ISM is installed and running to perform the
preparetoremove operation.
• secureerase— Specifies the PCIeSSD drive to perform the secure erase operation.
Example
Inventory
• To view the help details for get command, run the following command:
racadm>>storage help get
racadm storage help get
Storage monitoring and inventory of hardware RAID connected to the system.
Usage :
racadm storage get status
racadm storage help <Object type I/II>
racadm storage get <Object type I>
racadm storage get <Object type I> -current
racadm storage get <Object type I> -pending
racadm storage get <Object type I> -o
racadm storage get <Object type I> -o -p <property names separated by comma>
87