Reference Guide

encryptvd, enclosures, emms, fans, hotspare, importconfig,
ccheck, secureerase, preparetoremove, blink, unblink,
cancelcheck, init, modifysecuritykey, psus, pdisks,
resetconfig, tempprobes, vdisks, and patrolread.
• To create, delete, and secure the virtual disks. To start or stop the consistency check
on the specified virtual disk, run the following command:
racadm storage createvd:<Controller FQDD> -rl {r0|r1|r5|r6|r10|
r50|r60}[-wp {wt|wb|wbf}] [-rp {nra|ra|ara}] [-ss {1k|2k|4k|8k|
16k|32k|64k|128k|256k|512k|1M|2M|4M|8M|16M}]-pdkey:<comma
separated PD FQDD> [-dcp {enabled|disabled|default}] [-name <VD
name>] [-size <VD size>{b|k|m|g|t}] [-T10PIEnable]
racadm storage init:<VD FQDD> -speed {fast|full}
racadm storage deletevd:<VD FQDD>
racadm storage encryptvd:<VD FQDD>
racadm storage createsecuritykey:<Controller FQDD> -key <Key
id> -xxx <passphrase>
racadm storage modifysecuritykey:<Controller FQDD> -key <Key
id>-xxx <old passphrase> -xxx <new passphrase>
racadm storage deletesecuritykey:<Controller FQDD>
racadm storage ccheck:<vdisk fqdd>
racadm storage cancelcheck:<vdisk fqdd>
• To convert the physical disk drives and assign or delete a hotspare. To scan physical
disks connected to a controller and detect problem, run the following command:
racadm storage converttononraid:<PD FQDD>
racadm storage converttoraid:<PD FQDD>
racadm storage hotspare:<Physical Disk FQDD> -assign yes -type
dhs -vdkey: <FQDD of VD>
racadm storage hotspare:<Physical Disk FQDD> -assign yes –type
ghs
racadm storage hotspare:<Physical Disk FQDD> -assign no
racadm storage patrolread:<controller FQDD> -state start|stop
NOTE: If the –assign option is no, you cannot add other options. If the –
assign
option is yes and if the -type option is not present, the global
hotspare (ghs) is created by default.
• To reset, clear, and import the storage configuration to the controller, run the
following command:
racadm storage importconfig:<Controller FQDD>
racadm storage resetconfig:<Controller FQDD>
racadm storage clearconfig:<Controller FQDD>
• To start or stop a blink or identify operation on the specified or PCIeSSD device, run
the following command:
racadm storage blink:<FQDD>
racadm storage blink:<PCIeSSD FQDD>
racadm storage unblink:<FQDD>
racadm storage unblink:<PCIeSSD FQDD>
85