Reference Guide

• racadm set <FQDD Alias>.<group>.<object> <value>
• racadm set <FQDD Alias>.<group>.<index>.<object> <value>
• racadm set -f <filename> -t xml -u myuser -p xxx -l <CIFS or
NFS share>
• racadm set –f <filename> -t <filetype> -u <username> -p
<password> -l <CIFS or NFS share> --preview
• racadm set -f <filename> -t <filetype> -u <username> -p
<password> -l <CIFS or NFS share> -c <FQDD>
• racadm set -f <filename> -t <filetype> -u <username> -p
<password> -l <CIFS or NFS share> -c <FQDD>, <FQDD>, <FQDD>,
<FQDD>
Input
• <FQDD Alias>
• <group> — Specifies the group containing the object that must be written.
• <object> — Specifies the object name of the value that must be written.
• <index> — This option is specified where FQDD Aliases or Groups must be indexed.
• -f <filename> — Enables set to configure the device from a specified file. This
option is not supported in the Firmware RACADM interface.
• --continue — This option is used with –f only. If configuration through file is
unsuccessful for a group, then configuration continues with the next group in the
file. If this option is not used, then configuration stops when it is unsuccessful for a
particular group. After the unsuccessful group, the rest of the groups are not
configured.
• -u — Specifies user name of the remote share from where the file must be
imported.
• -p — Specifies password for the remote share from where the file must be imported.
• -l — Specifies network share location from where the file must be imported.
• -t — Specifies the file type that must be imported. Valid values are xml and ini.
These values are case-insensitive.
ini imports the legacy configuration file. The ini file
cannot be imported from a remote share. If -t is not specified, the ini file format
(default) is imported.
NOTE: To import or export .xml config files, Lifecycle Controller version 1.1 or
later is required.
• -b — Specifies the type of shutdown for the host after the import operation
completes. The parameters are
Graceful, Forced, and NoReboot for graceful
shutdown, forced shutdown, and no reboot respectively. If this parameter is not
specified, graceful shutdown is taken as the default.
NOTE: If the operating system is in use, then the graceful shutdown option
may time out within 300 seconds. If this operation is unsuccessful, then retry
with the force option.
• -w — Maximum time to wait for the graceful shutdown to occur. The value must be
entered in seconds. Minimum accepted value is 300 seconds and the maximum
accepted value is 3600 seconds. The default value is 1800 seconds.
• -s — Power state of the host when the import operation completes. The parameters
are "On" for powered ON and "Off" for powered OFF. If this parameter is not
specified, power ON is taken as default.
• --preview — Validate the configuration .xml file and view the status.
The --preview option includes the Job ID that is used to verify the status of the file
configuration before applying. The Job ID can be tracked by running the racadm
jobqueue view –I <JID>
command.
74