Reference Guide

• To get the network statistics, type the following command:

$ racadm nicstatistics

NIC.Slot.5-2-1 : QLogic CNA Gigabit Ethernet-B8:AC:6F:B3:BF:10

NIC.Slot.5-2-1 : QLogic CNA Gigabit Ethernet-B8:AC:6F:B3:BF:11

NIC.Slot.5-2-1 : QLogic CNA Gigabit Ethernet-B8:AC:6F:B3:BF:12

NIC.Slot.5-2-1 : QLogic CNA Gigabit Ethernet-B8:AC:6F:B3:BF:13

NIC.Slot.5-2-1 : QLogic CNA Gigabit Ethernet-B8:AC:6F:B3:BF:14

ping

Description Verifies if the destination IP address is reachable from iDRAC with the current routing-

table contents. A destination IP address is required. Based on the current routing-table

contents, an ICMP echo packet is sent to the destination IP address.

To run this subcommand, you must have the Debug privilege.

Synopsis

racadm ping <ipaddress>

Input <ipaddress> — The IP address of the remote endpoint to ping.

Output

PING 192.168.0 (192.168.0): 56 data bytes64 bytes from 192.168.0:

seq=0 ttl=64 time=4.121 ms

192.168.0 ping statistics

1 packets transmitted, 1 packets received, 0 percent packet

lossround-trip min/avg/max = 4.121/4.121/4.121 ms

ping6

Description

Verifies if the destination IPv6 address is reachable from iDRAC or with the current

routing-table contents. A destination IPv6 address is required. Based on the current

routing-table contents, an ICMP echo packet is sent to the destination IPv6 address.

To run this subcommand, you must have Debug privilege.

Synopsis

racadm ping6 <ipv6address>

Input <ipv6address> — the IPv6 address of the remote endpoint to ping.

Example

Pinging 2011:de11:bdc:194::31 from 2011:de11:bdc:194::101 with

32 bytes of data:

Reply from 2011:de11:bdc:194::31: time<1ms

Ping statistics for 2011:de11:bdc:194::31:

Packets: Sent = 4, Received = 4, Lost = 0 (0% loss),

Approximate round trip times in milli-seconds:

Minimum = 0ms, Maximum = 0ms, Average = 0ms