Users Guide

• To view the current firmware update schedule:

racadm AutoUpdateScheduler view

• To disable automatic firmware update:

racadm set lifecycleController.lcattributes.AutoUpdate.Enable 0

• To clear the schedule details:

racadm AutoUpdateScheduler clear

Updating firmware using CMC web interface

You can update iDRAC firmware for blade servers using the CMC Web interface.

To update iDRAC firmware using the CMC Web interface:

1. Log in to CMC Web interface.

2. Go to Server → Overview → <server name>.

The Server Status page is displayed.

3. Click Launch iDRAC Web interface and perform iDRAC Firmware Update.

Related Concepts

Updating device firmware

Downloading device firmware

Updating firmware using iDRAC web interface

Updating firmware using DUP

Before you update firmware using Dell Update Package (DUP), make sure to:

• Install and enable the IPMI and managed system drivers.

• Enable and start the Windows Management Instrumentation (WMI) service if your system is running

Windows operating system,

NOTE: While updating the iDRAC firmware using the DUP utility in Linux, if you see error

messages such as usb 5-2: device descriptor read/64, error -71 displayed on the

console, ignore them.

• If the system has ESX hypervisor installed, then for the DUP file to run, make sure that the

"usbarbitrator" service is stopped using command: service usbarbitrator stop

To update iDRAC using DUP:

1. Download the DUP based on the installed operating system and run it on the managed system.

2. Run the DUP.

The firmware is updated. A system restart is not required after firmware update is complete.

Updating firmware using remote RACADM

To update using remote RACADM:

1. Download the firmware image to the TFTP or FTP server. For example, C:\downloads\firmimg.d7

2. Run the following RACADM command:

TFTP server:

• Using fwupdate command: racadm -r <iDRAC IP address> -u <username> -p

<password> fwupdate -g -u -a <path>