Reference Guide

rollback

Description Allows you to roll back the firmware to an earlier version.

Synopsis

racadm rollback <FQDD>

NOTE: To get the list of available rollback versions and FQDDs, run the racadm

swinventory command.

Input <FQDD>: Specify the FQDD of the device for which the rollback is required.

Example

racadm rollback iDRAC.Embedded.1-1

RAC1056: Rollback operation initiated successfully.

sensorsettings

Description Allows you to perform threshold settings of the sensor.

To run this subcommand, you must have Configure iDRAC privilege.

NOTE: An error message is displayed when the following is performed:

• A set operation is performed on an unsupported FQDD.

• Out of range settings is entered.

• Invalid sensor FQDD is entered.

• Invalid threshold level filter is entered.

Synopsis

racadm sensorsettings set <FQDD> -level Min <value>

Input

• <FQDD> — Sensor or corresponding sensor FQDD which needs a threshold

configuration. Run the command, racadm getsensorinfo to view the sensor

FQDD. The

R/W field in the output getsensorinfo indicates if the sensor thresholds

can be configured. Replace the <FQDD> field with the corresponding sensor FQDD

that needs a threshold configuration.

• -level — threshold level for the sensor setting. Values are Max or Min.

Examples To set the minimum noncritical threshold level for a power sensor type.

racadm sensorsettings set iDRAC.Embedded.1#SystemBoardCPUUsage -

level Max 95

NOTE: The entered value must be lesser or higher than the sensor critical threshold

limit.

serveraction

Description Enables you to perform power management operations on the blade system.

To run this subcommand, you must have the Execute Server Control Commands

permission.

Synopsis

racadm serveraction <action> -f

• racadm serveraction -a <action>