Reference Guide

To use this subcommand with the set and test option, you must have the

Administrator privilege.

Synopsis

racadm eventfilters <eventfilters command type>

racadm eventfilters get -c <alert category>

racadm eventfilters set -c <alert category> -a <action> -n

racadm eventfilters set -c <alert category> -a <action> -r

racadm eventfilters test -i <Message ID to test>

NOTE: The general format of an alert category:

idrac.alert.category.[subcategory].[severity]

where, category is mandatory, but subcategory and severity are optional. A severity

cannot precede a subcategory.

Valid Category values are:

• All

• System

• Storage

• Updates

• Audit

• Config

• Worknotes

Valid Severity values are:

• Critical

• Warning

• Info

Valid examples of alert queries are:

• idrac.alert.all

• idrac.alert.audit

• idrac.alert.audit.lic

• idrac.alert.audit.warning

• idrac.alert.audit.lic.critical

Input

• get — Displays the list of eventfilter settings.

• set — Configures the actions and notifications for a given eventfilter configuration.

• -i — Message ID for which the simulation is needed.

• -c — Alert category of the specific event filter.

• -a — The action that must be invoked when the event occurs. Valid values are none,

powercycle, power off, or systemreset.

• -n — The notification is sent when the event occurs. Valid values are all, snmp,

ipmi, ws-events, oslog, email, remotesyslog or none. You can append

multiple notifications separated by a comma. You cannot enter the values all or

none with other notifications. If incorrect notification is specified along with other

valid notifications, the valid and invalid notification set is failed.