Reference Guide

Input N/A

Example

racadm arp

Output

Address HW Type HW Address Mask Device

192.168.1.1 Ether 00:0d:

65:f3:7c:bf

C eth0

autoupdatescheduler

Description You can automatically update the firmware of the devices on the server.

To run this subcommand, you must have the Server Control privilege.

NOTE:

• The autoupdatescheduler subcommand can be enabled or disabled.

• Lifecycle Controller and CSIOR may not be enabled to run this subcommand.

• The autoupdatescheduler can be enabled or disabled. For more information,

see LifecycleController.LCAttributes.autoupdate (Read or Write)

• The minimum Lifecycle Controller version required is Lifecycle Controller 1.3.

• The minimum Lifecycle Controller version required is Lifecycle Controller2 1.3.

• When a job is already scheduled and the clear command is run, the

scheduling parameters are cleared.

• If the network share is not accessible or the catalog file is missing when the job

is scheduled, then the job is unsuccessful.

Synopsis

• To create the AutoUpdateScheduler, run the command.

racadm autoupdatescheduler create -u <user> -p <password> -l

<location> -f <filename> -time <time> -dom <DayOfMonth> -wom

<WeekOfMonth> -dow <DayofWeek> -rp <repeat> -a <applyreboot> -

ph <proxyHost> -pu <proxyUser> -pp <proxyPassword> -po

• To view AutoUpdateScheduler parameter, run the command.

racadm autoupdatescheduler view

• To clear and display AutoUpdateScheduler parameter, run the command.

racadm autoupdatescheduler clear

NOTE: After the parameters are cleared, the AutoUpdateSchedular is disabled.

To schedule the update again, enable the AutoUpdateScheduler.

Input Valid options:

• -u — Specifies the user name of the remote share that stores the catalog file.

NOTE: For CIFS, enter the domain name as domain or username.

• -p — Specifies the password of the remote share that stores the catalog file.

• -l — Specifies the network share (NFS, CIFS, FTP, TFTP, or HTTP) location of the

catalog file. IPv4 and IPv6 addresses are supported.

• -f — Specifies the catalog location and the filename. If the filename is not

specified, then the default file used is catalog.xml.