Users Guide

• RAID controller
• Batteries
• CPUs
• DIMMs
• HDDs
• Backplanes
• Network Interface Cards (integrated and embedded)
• Video card
• SD card
• Power Supply Units (PSUs)
• Fans
• Fibre Channel HBAs
• USB
The Firmware Inventory section displays the firmware version for the following components:
• BIOS
• Lifecycle Controller
• iDRAC
• OS driver pack
• 32-bit diagnostics
• System CPLD
• PERC controllers
• Batteries
• Physical disks
• Power supply
• NIC
• Fibre Channel
• Backplane
• Enclosure
• PCIe SSDs
NOTE: On the Dell PowerEdge FX2/FX2s servers, the naming convention of the CMC version
displayed in the iDRAC GUI differs from the version displayed on the CMC GUI. However, the
version remains the same.
When you replace any hardware component or update the firmware versions, make sure to enable and
run the Collect System Inventory on Reboot (CSIOR) option to collect the system inventory on reboot.
After a few minutes, log in to iDRAC, and navigate to the System Inventory page to view the details. It
may take up to 5 minutes for the information to be available depending on the hardware installed on the
server.
NOTE: CSIOR option is enabled by default.
Click Export to export the hardware inventory in an XML format and save it to a location of your choice.
Viewing sensor information
The following sensors help to monitor the health of the managed system:
113