Release Notes

Issue 61:
Description
If Attach Mode is set to Detach on iDRAC Web interface (on the Attached Media page), then Map
CD/DVD and Map Remove Disk does not appear in the Virtual Media drop-down menu after Virtual
Media is connected from Virtual Console.
Resolution
No impact and can be ignored.
Versions/Systems Affected
All iDRAC7 supported Dell PowerEdge systems.
Issue 62:
Description
While executing a remote diagnostics from RACADM CLI, the diagnostic mode type of “2-Both” reports
as an invalid input.
Resolution
Diagnostics Mode type 2 is to execute both Express and Extended mode of the diagnostics operation.
This can be achieved by executing Mode 1 and Mode 2 individually for getting the required diagnostics
result.
Versions/Systems Affected
All iDRAC7 supported Dell PowerEdge systems.
Issue 63:
Description
According to NIST, key lengths providing less than 112 bits of security strength must not be used to
generate digital signatures after December 31, 2013. The self-signed SSL certificate provided with iDRAC7
1.55.55 is signed with a key length of 1024 bits which provides 80 bits of security strength. The next
release will provide a key length of 2048 to follow NIST recommendations.
Resolution
Option 1:
Provide in-house signed certificate using a key length of 2048 or greater and upload to iDRAC7.
Option 2:
Purchase third party signed certificate using a key length of 2048 or greater and upload to iDRAC7.
Versions/Systems Affected
All iDRAC7 supported Dell PowerEdge systems.
Issue 64:
Description
When OS to iDRAC pass-through feature is disabled or if it is set to LOM PT mode and if iDRAC Service
Module is installed on the host operating system, an incorrect warning message is displayed.
Resolution
Make sure that OS to iDRAC pass-through feature is enabled through the internal USB bus in iDRAC7.
Versions/Systems Affected
All 12th generation Dell PowerEdge systems with iDRAC7.