Reference Guide

– chassis

This option is applicable for CMC only.

• -l <ledstate> — Specifies whether the LED must blink.

<ledstate> can be one of the following:

– 0: no blinking

– 1: blinking

Example For CMC:

• racadm setled -m server-1 -1 1

LED state was set successfully.

• racadm setled -m server-9 -1 1

ERROR: Server in slot 9 is an extension of the server in slot 1.

NOTE: The setled command generates an error when run on the extension slot of a

multi-slot server.

For iDRAC:

racadm setled -l 1

LED state was set successfully.

setniccfg

Description Sets the iDRAC IP address. It displays an error message if the requested operation could not be

performed. A success message is displayed if the operation is completed successfully

To run this subcommand, you must have the Configure iDRAC permission.

NOTE: For CMC, the command helps to modify network configuration properties.

NOTE: The terms NIC and Ethernet management port may be used interchangeably.

Synopsis

• racadm setniccfg -d

• racadm setniccfg -d6

• racadm setniccfg -s <IPv4Address> <netmask> <IPv4 gateway>

• racadm setniccfg -s6 <IPv6 Address> <IPv6 Prefix Length> <IPv6

Gateway>

• racadm setniccfg -o

For CMC:

• racadm setniccfg -m <module> -v <vlan ID> <vlan priority>

• racadm setniccfg [-m chassis] -o

• racadm setniccfg –p [-6]

• racadm setniccfg -m <module> -k <speed> <duplex>

• racadm setniccfg -i <slot> -v <vlan ID> <vlan priority>

123