Reference Guide
For iDRAC, you must have the Execute Diagnostic Commands permission.
Synopsis
racadm ping <ipaddress>
Input
racadm ping 10.94.161.161
Output
PING 10.94.161.161 (10.94.161.161): 56 data bytes64 bytes from
10.94.161.161: seq=0 ttl=64 time=4.121 ms--- 10.94.161.161 ping
statistics ---1 packets transmitted, 1 packets received, 0 percent
packet lossround-trip min/avg/max = 4.121/4.121/4.121 ms
ping6
Description Verifies if the destination IPv6 address is reachable from iDRAC or CMC, or with the current
routing-table contents. A destination IPv6 address is required. Based on the current routing-table
contents, an ICMP echo packet is sent to the destination IPv6 address.
To run this subcommand for CMC, you must have the Administrator privilege.
For iDRAC, you must have the Execute Diagnostic Commands permission.
Synopsis
racadm ping6 <ipv6address>
Example
Pinging 2011:de11:bdc:194::31 from 2011:de11:bdc:194::101 with
32 bytes of data:
Reply from 2011:de11:bdc:194::31: time<1ms
Reply from 2011:de11:bdc:194::31: time<1ms
Reply from 2011:de11:bdc:194::31: time<1ms
Reply from 2011:de11:bdc:194::31: time<1ms
Ping statistics for 2011:de11:bdc:194::31:
Packets: Sent = 4, Received = 4, Lost = 0 (0% loss),
Approximate round trip times in milli-seconds:
Minimum = 0ms, Maximum = 0ms, Average = 0ms
racdump
Description Provides a single command to get dump, status, and general iDRAC board information.
For CMC, this subcommand displays the comprehensive chassis status, configuration state
information, and historic event logs. Used for post deployment configuration verification and during
debugging sessions.
To run this subcommand for CMC, you must have the Administrator privilege.
For iDRAC, you must have the Debug permission.
Synopsis
racadm racdump
Input
Racdump includes the following subsystems and aggregates the following RACADM commands:
• General System/RAC information — getsysinfo
• Session information — getssinfo
• Sensor information — getsensorinfo
• Switches information (IO Module) — getioinfo
• Mezzanine card information (Daughter card) — getdcinfo
• All modules information — getmodinfo
• Power budget information — getpbinfo
• KVM information — getkvminfo
102