Reference Guide

Introduction

This document provides information about the RACADM subcommands, supported RACADM interfaces, and property

database groups and object definitions for the following:

• iDRAC Enterprise or Express for Blade Servers

• iDRAC Enterprise or Express on Rack and Tower Servers

• Dell Chassis System (CMC)

New In The Release

The following are the new subcommands and groups added in this release:

• inlettemphistory

• testalert

• iDRAC.SNMP.Alert

• iDRAC.SNMP.Alert.[i].DestAddr (Read or Write)

Information for the following subcommands and groups has been updated in this release:

• arp

• config

• ifconfig

• inlettemphistory

• ping

• ping6

• remoteimage

• traceroute

• traceroute6

• iDRAC Type Read Only

• cfgNicSelection Read or Write

• cfguserdomainname Read Only

• cfgVFlashPartitionOSVolLabel

• System.Power.Hotspare.Enable Read or Write

• cfgRacSecCsrKey Read or Write

Downloading And Installing Supported RACADM Interfaces

The RACADM command-line utility provides a scriptable interface that allows you to locally or remotely configure your

Remote Access Controller (RAC). The utility runs on the management station and the managed system. It is available on

the

Dell OpenManage Systems Management and Documentation

DVD or at support.dell.com.