White Papers

Integrating iDRAC7 with Active Directory
23
Viewing Active Directory Schema Changes (Optional)
To view the changes made by extending the schema, install the Microsoft Active Directory Schema
snap- in utility. To do this:
1. At the command prompt, type the following command, and then press ENTER:
regsvr32 schmmgmt.dll
2. A message is displayed indicating that the command is successful. Click OK.
3. Open the saved Console1.msc (or create a new one by running MMC).
4. Click File > Add/Remove Snap In.
5. Select Active Directory Schema, click Add, and then click OK.
6. Expand Active Directory Schema and expand Classes. In the right pane, you can locate the added
classes prefixed with "dell".
7. Under Active Directory Schema, click the Attributes folder. In the right pane, you can locate the
added attributes prefixed with "dell".
Installing Dell Extension to Active Directory Users and Computers
Snap-In
Note: If your domain controller is running 64-bit Windows and you are using the Systems Management
Tools and Documentation DVD version 7.0.0 or 7.1.0, see the next section. If you are using the DVD
version 7.2.0 or later, this section applies to both 32-bit and 64-bit operating systems. This section also
applies if you are using version 7.0.0 or 7.1.0 of the DVD and a 32-bit operating system.
Install the Dell extension to the Active Directory Users and Computers Snap-In as follows:
1. From the Systems Management Tools and Documentation DVD, run Autorun.exe.
2. If a Security Warning message is displayed, click Run.
3. Select Active Directory Snap-In Utility and then click Install.