Reference Guide

Table Of Contents

FanSpeed 8 Fan-8 Not OK 1 rpm 7250 14500

FanSpeed 9 Fan-9 OK 4826 rpm 2344 14500

<uc>

Temp 1 Ambient_Temp OK 21 celcius N/A 40

senType> <Num> <sensorName> <status> <AC-OK status>

PWR 1 PS-1 Online OK

PWR 2 PS-2 Online OK

PWR 3 PS-3 Online OK

PWR 4 PS-4 Slot Empty N/A

PWR 5 PS-5 Failed OK

PWR 6 PS-6 Slot Empty N/A

racreset

Description Issues a reset to iDRAC. The reset event is written into

iDRAC log.

To use this subcommand for CMC you must have Chassis

Administrator privilege and for iDRAC you must have

Configure iDRAC permission.

NOTE: When you issue a racreset subcommand,

iDRAC may require up to two minutes to return to a

usable state.

NOTE: You must reboot your system after performing a

hard reset of iDRAC.

Synopsis

racadm racreset [hard | soft]

Input

• hard - A hard reset performs a deep reset

operation on the remote access controller. A hard

reset should only be used as a last case resort of

resetting iDRAC controller for recovery purposes.

• soft - A soft reset performs a graceful reboot

operation on the RAC.

Output

• racadm racreset

RAC reset operation initiated successfully. It may take up

to a minute for the RAC to come online again."

• racadm racresetcfg -

The RAC configuration has initiated

restoration to factory

defaults. Please wait for a minute for

this process to complete

before accessing the RAC again.

Example

• Start the iDRAC soft reset sequence.

racadm racreset

• Start the iDRAC hard reset sequence.

racadm racreset hard