Reference Guide

NOTE: For iDRAC only, before you execute the testtrap subcommand, make sure that
the specified index in the RACADM cfgIpmiPet group is configured properly. The
cfgIpmiPet group is applicable only for iDRAC.
NOTE: For CMC only, before you execute the testtrap subcommand, make sure that
the specified index in the RACADM cfgAlerting group is configured properly. The
cfgAlerting group is applicable only for CMC.
Synopsis
racadm testtrap -i <index>
Input -i — Specifies the index of the trap configuration to be used for the test. Valid values are
from 1 to 4.
Example
Commands for the cfgIpmiPet group:
• Enable the alert
racadm config -g cfgIpmiPet -o cfgIpmiPetAlertEnable -
i 1
1
• Set the destination e-mail IP address
racadm config -g cfgIpmiPet -o
cfgIpmiPetAlertDestIpAddr -i 1 192.168.0.110
• View the current test trap settings
racadm getconfig -g cfgIpmiPet -i <index
>
where < index > is a number from 1 to 4
traceroute
Description Traces the network path of routers that packets take as
they are forwarded from your system to a destination IPv4
address.
To use this subcommand, you must have Administrator
permission.
Synopsis
racadm traceroute <IPv4 address>
racadm traceroute 192.168.0.1
Input
racadm traceroute 192.168.0.1
Output
traceroute to 192.168.0.1
(192.168.0.1), 30 hops
max,
40 byte packets
1 192.168.0.1 (192.168.0.1) 0.801 ms
0.246 ms 0.253 ms
103