Release Notes
Table Of Contents
- iDRAC8/7 with Lifecycle Controller Version 2.60.60.60 Release Notes
- Overview
- Platforms affected
- What is supported
- New in this release
- Fixes
- Important notes
- Limitations
- Known Issues — To be fixed in future releases
- Installation
- Lifecycle Controller Remote Services — client tools
- Accessing documents from Dell Support site
- Contacting Dell EMC
Perform a Power Cycle operation on the server.
Systems aected: All systems supported by this release.
Tracking number: N/A
5 Description
On 12
th
generation of PowerEdge servers, while deploying the operating system by selecting the UEFI boot mode, an error message is
displayed when you click Finish. This error occurs if you try to connect the optical drive or virtual media after you launch Lifecycle
Controller.
Workaround
Reboot the server and ensure that you connect the optical drive or virtual media before launching Lifecycle Controller.
Systems aected: All systems supported by this release.
Tracking number: N/A
6 Description
ValueName regex does not match the schema denition for some of the properties in the BIOS Attribute Registry and the Boot
Sources Registry returned by Redsh API.
Workaround
Defer the regex check for the ValueName returned for BIOS Attribute Registry and the Boot Sources Registry against the schema.
Systems aected: All systems supported by this release.
Tracking number: 97643
7 Description
Using remote RACADM, a hardware inventory export operation to a local share fails. This issue occurs only with OpenManage 9.1.0.
Workaround
Use one of the following methods to export the hardware inventory:
• Use an earlier version of OpenManage, such as OpenManage 8.5.
• Export the hardware inventory using rmware RACADM to a NFS or CIFS share.
• Use local RACADM.
Systems aected: All systems supported by this release.
Tracking number: 83908
8 Description
iDRAC rmware update using RACADM fails and incorrect version information is displayed with OpenManage 9.1.0.
Workaround
Update the rmware using other methods such as iDRAC web interface or using DUPs through the operating system.
Systems aected: All systems supported by this release.
Tracking number: 83577, 84851
9 Description
While deploying OS using LC UI, if the current boot mode is set to UEFI and you change the boot mode to BIOS and click Finish on
the last LC UI page, an error is displayed stating that the boot mode could not be set. The system reboots after you click OK.
However, on next boot to LC UI, the boot mode is changed to BIOS and the boot device selected during OS deployment is discarded.
Workaround
Before deploying OS using LC UI, change the boot mode to BIOS from BIOS setup (F2 at POST).
Known Issues — To be
xed in future releases 17