CLI Guide

Max Number of IOs per connection supported: 9
Maximum number of Logins per port: 8
Maximum number of exchanges: 9
Maximum NPIV per port: 1
Maximum number of FC Targets supported: 8
Maximum number of outstanding commands across all connections: 9
Flex Addressing: Capable
UEFI: Capable
FC Start: Capable
On Chip Thermal Sensor: Capable
Feature Licensing: Not Capable
ifcong
Table 58. Details of ifcong attribute
Description Displays the contents of the network interface table.
To use this subcommand, you must have the Execute Diagnostic Commands permission.
Synopsis
racadm ifconfig
Input N/A
Table 59. Example
eth0 Link encap:Ethernet HWaddr 00:1D:09:FF:DA:23
inet addr:192.168.0.0 Bcast:192.168.0.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:2550665 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:272532097 (259.9 MiB) TX bytes:0 (0.0 B)
inlettemphistory
Table 60. Details of inlettemphistory
Description
Displays the average and the peak temperatures during the last hour, day, week, month, or year. Also Exports the
inlet temperature history data le. The le can be exported to a remote le share, local le system, or the
management station.
NOTE: For FM120x4 systems, this subcommand provides the historical data for system board
temperature.
Synopsis
• racadm inlettemphistory export –f <filename> –t <type> [–u <username of the
network share>] [–p <password for the remote share>] [-i <network share
location>]
• racadm inlettemphistory get
Input
• -f — Exports inlet temperature history lename. The maximum length of this parameter is 64 characters.
NOTE: If a le with the specied lename exists, then the older le is replaced with the new history
le.
• -u — User name of the remote share to export the le. Specify user name in a domain as domain or username.
•
-p — Password for the remote share to where the le must be exported.
• -l — Network share location to where the inlet temperature history must be exported. The maximum length of
this parameter is 256 characters.
RACADM Subcommand Details 79