CLI Guide
arp
Table 4. arp table
Description
Displays the contents of the Address Resolution Protocol (ARP) table. ARP table entries cannot be added or deleted.
To use this subcommand, you must have Debug privilege.
Synopsis
racadm arp
Input N/A
Example
racadm arp
Table 5. Output
Address HW Type HW Address Mask Device
192.168.1.1 Ether 00:0d:65:f3:7c:bf C eth0
autoupdatescheduler
Table 6. Details of autoupdatescheduler
Description You can automatically update the rmware of the devices on the server.
To run this subcommand, you must have the Server Control privilege.
NOTE:
• The autoupdatescheduler subcommand can be enabled or disabled.
• Lifecycle Controller and CSIOR may not be enabled to run this subcommand.
• The autoupdatescheduler can be enabled or disabled. For more information, see
LifecycleController.LCAttributes.autoupdate (Read or Write)
• The minimum Lifecycle Controller version required is Lifecycle Controller 1.3.
• When a job is already scheduled and the clear command is run, the scheduling parameters are cleared.
• If the network share is not accessible or the catalog le is missing when the job is scheduled, then the
job is unsuccessful.
Synopsis
• To create the AutoUpdateScheduler, run the command.
racadm autoupdatescheduler create -u <user> -p <password> -l <location> -f
<filename> -time <time> -dom <DayOfMonth> -wom <WeekOfMonth> -dow
<DayofWeek> -rp <repeat> -a <applyreboot> -ph <proxyHost> -pu <proxyUser> -
pp <proxyPassword> -po <proxyPort> -pt <proxyType>
• To view AutoUpdateScheduler parameter, run the command.
racadm autoupdatescheduler view
• To clear and display AutoUpdateScheduler parameter, run the command.
racadm autoupdatescheduler clear
NOTE: After the parameters are cleared, the AutoUpdateScheduler is disabled. To schedule the
update again, enable the AutoUpdateScheduler.
Input Valid options:
• -u — Species the user name of the remote share that stores the catalog le.
RACADM Subcommand Details 45