Users Guide

The vFlash SD Card page is displayed.

5 From the vFlash SD card drop-down menu, select Enabled or Disabled.

6 Click Finish to apply the changes.

Initializing a vFlash SD card

1 Start Lifecycle Controller. For more information, see Starting Lifecycle Controller.

2 In the left pane, click Hardware Conguration.

3 In the right pane, click Conguration Wizards.

4 On the System Conguration Wizards page, click vFlash SD Card Conguration.

The vFlash SD Card page is displayed.

5 Click Initialize vFlash to delete all the data present in the vFlash SD card.

NOTE: The Initialize vFlash option is not available after you disable the vFlash SD card.

Conguring RAID

If your system has one or more supported PERC RAID controllers with PERC 8 rmware or later, or software RAID controllers, use the

RAID Conguration wizard to congure a virtual disk as the boot device.

NOTE: Create boot virtual disk only from disk drive populated across slots 0–3 of the system. For slot information, see the server

Owner’s Manual at dell.com/poweredgemanuals.

NOTE: If there are any internal storage controller cards on the system, all other external cards cannot be congured. The

external cards can be congured only if there are no internal cards.

To congure RAID:

1 Start Lifecycle Controller. For more information, see Starting Lifecycle Controller.

2 In the left pane, click Hardware Conguration.

3 In the right pane, click Conguration Wizards.

4 Under Storage Conguration Wizards, click RAID Conguration to launch the wizard.

The View Current RAID Conguration and Select Controller page is displayed.

5 Select the controller and click Next.

The Select RAID Level page is displayed.

6 Select the RAID level and click Next.

The Select Physical Disks page is displayed.

7 Select the physical disk's properties and click Next.

The Virtual Disk Attributes page is displayed.

8 Select the virtual disk parameters and click Next.

The Summary page is displayed.

9 To apply the RAID conguration, click Finish.