Users Guide

Post reboot scenarios

The following table lists the post reboot scenarios, its user actions, and impact.

Table 7. Post reboot scenarios

Scenario User Action and Impact

During POST, the system prompts you to press a key to

boot to the operating system installation media.

Press any key to begin the operating system installation; else, the system

boots to the hard-disk drive and not the operating system installation media.

Operating system installation is interrupted and the

system restarts before the installation is completed.

The system prompts you to press a key to boot from the operating system

installation media.

Cancel operating system installation. Press <F10>.

NOTE: If you press <F10> during the installation process or a

restart, the drivers provided by the operating system deployment

wizard are removed.

During the 18-hour period when drivers are extracted to a

temporary location after the operating system is installed,

you cannot update the component rmware using a DUP.

If you attempt a DUP through the operating system

during this time period, the DUP displays a message that

another session is active.

Lifecycle Controller does not allow DUP after the operating system

installation. However, if you disconnect the power supply to the managed

system, the OEMDRV directory is erased.