Users Guide

Table 9. Thermal Settings (continued)
Object Description Usage Example
and the
FanSpeedLowOffsetVa
l,
FanSpeedMaxOffsetVa
l,
FanSpeedHighOffsetV
al, and
FanSpeedMediumOffse
tVal objects (defined
earlier) are the values at
which the offsets are
applied.
To set the fan speed offset
to High value (as defined in
FanSpeedHighOffsetVal)
racadm set
system.thermalsetti
ngs.FanSpeedOffset
1
MFSMaximumLimit
Read Maximum limit for MFS
Values from 1 — 100 To display the highest value
that can be set using
MinimumFanSpeed option:
racadm get
system.thermalsetti
ngs.MFSMaximumLimit
MFSMinimumLimit
Read Minimum limit for MFS
Values from 0 to
MFSMaximumLimit
Default is 255 (means None)
To display the lowest value
that can be set using
MinimumFanSpeed option.
racadm get
system.thermalsetti
ngs.MFSMinimumLimit
MinimumFanSpeed
● Allows configuring the
Minimum Fan speed that is
required for the system to
operate.
● It defines the baseline
(floor) value for fan speed
and system allows fans to
go lower than this defined
fan speed value.
● This value is %PWM value
for fan speed.
Values from
MFSMinimumLimit to
MFSMaximumLimit
When get command reports
255, it means user configured
offset is not applied.
To make sure that the system
minimum speed does not
decrease lower than 45%
PWM (45 must be a value
between MFSMinimumLimit
to MFSMaximumLimit):
racadm set
system.thermalsetti
ngs.MinimumFanSpeed
45
ThermalProfile
● Allows you to specify the
Thermal Base Algorithm.
● Allows you to set the
system profile as required
for thermal behavior
associated to the profile.
Values:
● 0 — Auto
● 1 — Maximum
performance
● 2 — Minimum Power
To view the existing thermal
profile setting:
racadm get
system.thermalsetti
ngs.ThermalProfile
To set the thermal profile to
Maximum Performance:
racadm set
system.thermalsetti
ngs.ThermalProfile
1
56 Setting up managed system and management station